SAE USCAR-1

SALT SPRAY TESTING AND EVALUATION OF FASTENER FINISHES

English 2005

0.000

Detailed Information

This procedure is used to test and evaluate the resistance of fastener surface finishes to laboratory salt spray testing.

Download File

(Log in to download spec.)

Check out other specifications

JIS

JIS B 1010

2003

English

Designation system for fasteners

This Standard specifies a system for the designation of fasteners in product standards.

ASME

ASME B18.1.1

2001

English

SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER

This standard covers complete general and dimensional data for those types of small solid rivets recognized as "American National Standard." All other types of small solid rivets, within the li [...]

DIN

DIN 46241-2

1963

English

Telecommunications Engineering – Contact Rivets – Soldered or Welded – Technical Conditions of Delivery

These conditions of delivery apply to contact rivets according to DIN 46240 Sheet 2 with soldered-on or welded-on tip (at manufacturer's option) in contact materials which are not capable of be [...]

ISO

ISO 12683

2004

English

Mechanically deposited coatings of zinc — Specification and test methods

This document specifies the requirements for coatings of zinc that have been mechanically deposited on to fabricated metal articles to protect them from corrosion. It also describes the related [...]

ISO

ISO 888

1976

English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.

DIN

DIN 267-12

1971

English

Bolts, Screws, Nuts and Similar Threaded and Formed Parts – Technical Conditions of Delivery – Self-Tapping Screws

The provisions of this Standard supplement DIN 267 Part 1, Part 2, Part 5, Part 7 and Part 9 and apply to self-tapping screws made of heat-treated steel except when there are compelling reasons [...]

DIN

DIN 1478

1975

English

Turnbuckles Made from Steel Tube or Round Steel Bar

The dimensions of turnbuckle nuts up to M 48 have been related to tubes according to DIN 2448 and brought into line with DIN 82004.

DIN

DIN 267-2

1984

English

Fasteners – Technical delivery conditions – Design and dimensional accuracy

This standard supplements DIN ISO 4759 Part 1 and applies to those product standards (dimensional standards) in which DIN 267 Part 2 is referred to, e.g. with regard to the surface roughness of [...]

DIN

DIN 980

1987

English

All-metal prevailing torque type hexagon nuts

This standard specifies requirements for M3 to M39 prevailing torque type hexagon nuts (all-metal nuts), assigned to product grade A for sizes up to M16, and to product grade B for sizes over M16.