DIN 435
Square taper steel washers for use with I sections
English
2000
0.000
Detailed Information
This standard specifies dimensions and technical delivery conditions for square taper washers for use in structural bolting of steel I sections using bolts up to property class 5.6.
Download File
(Log in to download spec.)
Check out other specifications
1976
English
Thread run-outs for fasteners with thread in accordance with ISO 261 and ISO 262
This International Standard specifies thread run-outs for fasteners with thread in accordance with ISO 261, ISO general purpose metric screw threads - General plan, and with ISO 262, ISO general purpose metric screw threads - Selected sizes for screws, bolts and nuts. It does not apply to those ...
2009
English
COATINGS OF ZINC MECHANICALLY DEPOSITED ON IRON AND STEEL
This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 μm. The seven thickest classes are usually referred to as “mechanically galvanized."
1993
English
METRIC HEXAGON SOCKET BUTTON HEAD CAP SCREWS
1.1.1 This standard contains the complete general and dimensional requirements for metric series hexagon socket button head cap screws of nominal sizes from 3 mm to 16 mm recognized as an American National Standard. Also included are appendices covering formulas for dimensions, part numbering sys...
1995
English
Self-drilling tapping screws – Dimensions, requirements and testing
This standard specifies dimensions. requirements and test methods for heat-treated self-drilling tapping screws ('tapping screws' for short). These screws have a drill point with which they form a pilot hole during assembly, followed by a threaded section with which they form their mating thread,...
1999
English
BLIND RIVETS GLOSSARY OF TERMS
This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivets and ot...