Abstract of ASTM F594
STAINLESS STEEL NUTS
English
2002
0.000
Detailed Information
1.1 This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in. in nominal diameter inclusive in a number of alloys in common use and intended for service applications requiring general corrosion resistance.
Download File
(Log in to download spec.)
Check out other specifications
1998
English
Standard Specification for Alloy Steel Socket-Head Cap Screws
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1-A complete metric companion to Specification A 574 has been developed-A 574M; therefore no metric equivalent...
2001
English
Overview of European Standards for fasteners
This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1); b) numerical indexes of DIN EN Standards (table 2)...
2009
English
COATINGS OF ZINC MECHANICALLY DEPOSITED ON IRON AND STEEL
This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 μm. The seven thickest classes are usually referred to as “mechanically galvanized."
1970
English
Steel Conduit Thread – Thread Gauges
The "Go" thread ring gauge must be capable of being screwed by band, without the application or undue force, over the full length of the workpiece thread. The "Not go" thread ring gauge must be incapable or passing over the thread. The "Go" thread plug gauge must be capable of being screwed by h...
1971
German
Sechskant-Paßschrauben mit kurzem Gewindezapfen
Bezeichnung einer Sechskant-Paßschraube mit Gewinde d1 = M20, Länge l = 80 mm und Festigkeitsklasse 5.6: Paßschraube M20 x 80 DIN 610 - 5.6 Bezeichnung einer Sechskant-Paßschraube mit Gewinde d1 = M20 X 1,5, Schaftdurchmesser d3 = 21,3 mm, Länge l = 80 mm und Festigkeitsklasse 5.6: Paßschraube M2...
1973
English
Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs
This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compression springs can be made with wire up to about 17 mm diameter. In the range from 10 to 17 mm wire diamete...