This Japanese Industrial Standard specifies the inspection method of taper screw gauges for pipes specified in JIS B 0253 (hereafter referred to as the "taper screw gauges"). Furthermore, the inspection method for the taper screw gauges specified in Appendix of JIS B 0253 is specified in Appendix.

This International Standard specifies the characteristics of plain washers for clevis pins according to ISO 2340 and ISO 2341. Plain washers in accordance with this International Standard shall be used on the cotter pin end only.

Technical conditions of delivery according to DIN 267

This International Standard specifies the dimensions of split pins of the metric series.

1. All dimensions are in inches. 2. Top Surfaces of Nuts. Nuts shall be double chamfered. The diameter of chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The length of chamfer at hex corners shall be from 5 to 15 percent of the basic thread ...

Parallel pins in accordance with this 5tandard are designed for the fastening of two or more individual elements. A friction type connection can be achieved by the selection of suitable fits If such a connection is meant to be disconnected repeatedly, then it becomes preferable to use taper pins ...