Abstract of ASTM F912M

ALLOY STEEL SOCKET SET SCREWS [METRIC]

English 1997
0.000
ASTM
Detailed Information

1.1 This specification covers the requirements for quenched and tempered alloy steel socket set screws (SSS) M 1.6 through M24 sizes having hardnesses 45 to 53 HRC, ISO 898/5 Property Class 45H.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM A194/A194M
2010
English

CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the size range 1/4 in. nominal and above. These nuts are intended for high-pressure or high-temperature ser...
ISO
ISO 7415
1984
English

Plain washers for high-strength structural bolting, hardened and tempered

This International Standard specifies those hardened and tempered circular washers intended for assembly with large series hexagon high-strength structural bolts and nuts of diameters from M12 to M36 inclusive.
DIN
DIN 6924
1987
English

Prevailing torque type hexagon nuts with nonmetallic insert

This standard specifies requirements for M3 to M48 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A (for sizes up to M16) and product grade B (for sizes over M16). If, in special cases, nuts are to comply with specifications other than those given in this ...
DIN
DIN 928
2000
English

Square weld nuts

This standard specifies requirements for sizes M4 to M16 coarse and fine pitch thread square weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN EN ISO 898-1.
ISO
ISO 3269
1988
English

Fasteners – Acceptance inspection

1.1 This International Standard specifies the procedure to be followed by the purchaser at his acceptance inspection in order to decide whether a lot of fasteners may be accepted or rejected, when no other acceptance procedure has been agreed with the supplier at the time of ordering the fastener...
DIN
DIN 50961
2000
German

Galvanische Überzüge – Zinküberzüge auf Eisenwerkstoffen – Begriffe, Korrosionsprüfung und Korrosionsbeständigkeit

Diese Norm gilt nur in Verbindung mit DIN EN 12329, die Anforderungen an galvanisch abgeschiedene Zinküberzüge mit zusätzlicher Behandlung festlegt. In Ergänzung zu DIN EN 12329 legt diese Norm für verschiedene Beanspruchungsstufen die Mindestkorrosionsbeständigkeiten nach DIN 50018 KFW 2,0 S, s...