DIN 1157

Decorator’s tacks

English 1973

0.000

Detailed Information

Decorator’s tacks shall be made of steel (grade at manufacturer’s discretion) and have a bright (bk) or blue annealed (bl g) finish.

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 6883

1956

English

Taper Key Torque Transmission – Parallel Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

DIN

DIN 7168

1991

English

General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)

This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted correctly, and also to inform the user of this standard that, for all new designs, tolerances are to be speci...

DIN

DIN 7983

1990

English

Cross recessed raised countersunk head tapping screws

DIN 7504 shall apply with regard to tapping screws with drilling tip (self-drilling screws). The DIN 4000 - 2 - 1 tabular layout of article characteristics shall apply for screws as covered in this standard.

DIN

DIN 7513

1995

English

Hexagon head and slotted head thread cutting screws – Dimensions, requirements and testing

This standard specifies dimensions. requirements and test methods for heat-treated hexagon head and slotted head thread cutting screws with an ISO metric thread as specified in DIN 13-12, with cutting flutes extending from the point of the screw to its head, and designed to cut their mating threa...

DIN

DIN 435

2000

English

Square taper steel washers for use with I sections

This standard specifies dimensions and technical delivery conditions for square taper washers for use in structural bolting of steel I sections using bolts up to property class 5.6.

ISO

ISO 1483

1983

English

Slotted raised countersunk (oval) head tapping screws (common head style)

This International Standard specifies the characteristics of slotted raised countersunk (oval) head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.