DIN EN 24035
Hexagon thin nuts (chamfered) Product grades A and B (ISO 4035 : 1986) English version of DIN EN 24 035
English
1992
0.000
Detailed Information
This International Standard gives specifications for chamfered hexagon thin nuts, with thread diameters from M1,6 to M64 inclusive, with product grade A for sizes d M16.
Download File
(Log in to download spec.)
Check out other specifications
1995
English
Studs – with a length of engagement equal to about 1,25 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in cast iron. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.
1983
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Festigkeitsklassen für Muttern (bisherige Klassen)
Im Jahre 1967 wurde die Norm DIN 267 Teil 4 auf internationale Festigkeitsklassen für Muttern umgestellt. Die alten Kennzeichen 4D, 5D, 5S, 6G, 6S und 8G wurden durch die Kennzahlen 4, 5, 6, 8, 10, 12 urid 14 ersetzt, wobei die Kennzahl 1/100 der Mindestzugfestigkeit (N/mm2) der Schraube entsprac...
2002
English
STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...
1978
English
Grooved Pins, Half Length Grooved with Gorge
Grooved pins according to this Standard are positive or non-positive connecting elements. They are used for holding retaining rings, retaining washers, springs, etc., the grooved pin being seated firmly in the accommodating hole, for which tolerance zone H11 is recommended.
1997
English
COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are covered: ...