DIN EN 28749
Determination of shear strength of pins (ISO 8749 : 1986) English version of DIN EN 28 749
English
1992
0.000
Detailed Information
This International Standard specifies the test method for shear testing of metallic pins with nominal diameters from 0,8 to 25 mm inclusive.
Download File
(Log in to download spec.)
Check out other specifications
2002
English
INSPECTION AND QUALITY ASSURANCE FOR SPECIAL PURPOSE FASTENERS
This standard outlines a Quality Assurance Plan for internally and externally threaded fasteners and accessories or associated parts. Provisions are included for sampling plans, inspection frequencies, control procedures, record keeping and disposition of nonconforming materials and parts. The ba...
1999
English
SQUARE AND HEX BOLTS AND SCREWS (INCH SERIES)
This Standard covers the complete general and dimensional data for eight product types of inch series square and hex bolts and screws recognized as American National Standard. Also included are appendixes covering thread runout sleeve gages, gaging procedure for checking bolt and screw straightne...
2002
English
STRUCTURAL BOLTS, ALLOY STEEL, HEAT TREATED, 150 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of quenched and tempered, alloy steel, heavy hex structural bolts having a tensile strength of 150 to 173 ksi. 1.2 These bolts are intended for use in structural connections. These connections are covered under the requirements of the Specification for Stru...
1998
English
Widening test on nuts
This Standard specifies the test procedure for evaluating the acceptability of surface discontinuities designated in JIS B 1042 excluding nuts made of free cutting steel. It applies to nuts with — nominal thread diameter, d, from 5 mm up to and including 39 mm; — product grades A and B; — prop...
1999
English
SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A
DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.
1978
English
Grooved Pins, Half Length Grooved with Gorge
Grooved pins according to this Standard are positive or non-positive connecting elements. They are used for holding retaining rings, retaining washers, springs, etc., the grooved pin being seated firmly in the accommodating hole, for which tolerance zone H11 is recommended.