ISO 273
Fasteners — Clearance holes for bolts and screws
English
1979
0.000
Detailed Information
This International Standard specifies clearance hole diameters for general purpose applications. These values result from bearing area calculations in connection with ISO bolt and nut product standards.
Download File
(Log in to download spec.)
Check out other specifications
1993
English
Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural Steel Joints [Metric]
1.1 This specification covers the chemical and mechanical requirements of quenched and tempered steel bolts, in nominal thread diameters M16 to M36, inch. These bolts are intended for use in st [...]
2008
English
SERRATED HEX FLANGE LOCKNUTS 90,000 psi (INCH SERIES)
This Standard covers the general, dimensional, and mechanical performance requirements for low strength carbon steel, case hardened, regular and large serrated flange locknuts (inch series), re [...]
1990
English
General rules for tightening of threaded fasteners
This Japanese Industrial Standard specifies general matters relating to significance of tightening by combination of bolt and nut, basis of tightening and representative control method. Furthe [...]
1993
English
METRIC HEXAGON SOCKET FLAT COUNTERSUNK HEAD CAP SCREWS
1.1.1 This standard contains complete general and dimensional requirements for metric series hexagon socket flat countersunk head cap screws of nominal sizes from 3 mm to 20 mm recognized as Am [...]
1996
English
METRIC ROUND HEAD SHORT SQUARE NECK BOLTS
This standard covers the general and dimensional data for metric series round head short square neck bolts recognized as American National Standard and intended primarily for applications in th [...]
2012
English
Mechanical properties of fasteners made of carbon steel and alloy steel — Part 2: Nuts with specified property classes — Coarse thread and fine pitch thread
This part of ISO 898 specifies mechanical and physical properties of nuts with coarse thread and fine pitch thread made of carbon steel and alloy steel when tested at an ambient temperature ran [...]