Check out other specifications
1998
English
Grooved pins, full-length parallel grooved, with chamfer (ISO 8740: 1997)
This International Standard specifies the characteristics of full-length parallel grooved pins made of steel or austenitic stainless steel with chamfer which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with nominal diam...
1977
English
Design and selection of chain drives
1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and of chain wheels with toothing as specified in DIN 8196 Part 1.
1991
English
General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)
This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted correctly, and also to inform the user of this standard that, for all new designs, tolerances are to be speci...
2011
English
Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) and veri...
