Check out other specifications
2014
English
Metallic materials — Brinell hardness test — Part 1: Test method
This part of ISO 6506 specifies the method for the Brinell hardness test for metallic materials. It is applicable to both fixed location and portable hardness testing machines. For some specific materials and/or products, particular International Standards exist (e.g. ISO 4498) and make referenc...
1999
English
COATING, OXIDE, BLACK, FOR FERROUS METALS
This specification covers black oxide coatings applied to ferrous metals (wrought iron, carbon, low alloy, and corrosion resistant steels). Black oxide coatings, with or without a supplementary preservative treatment (see 3.11), may be used where a black surface is required. Only very limited cor...
1999
English
METRIC PULL THROUGH MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.
2015
English
High-strength structural bolting assemblies for preloading Part 6: Plain chamfered washers
This European Standard specifies, together with EN 1 4399-1 and EN 1 4399-2, hardened and tempered chamfered plain washers with chamfer intended for bolting assemblies with large series hexagon high-strength structural bolts and nuts with thread sizes from M12 to M36 inclusive. Washers according...
1985
English
Hexagon socket thin head cap screws with pilot recess for wrench key
This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to propert...
1991
English
Mechanical properties of fasteners – Nonferrous metal bolts, screws, studs and nuts (ISO 8839 : 1986) (English version of DIN EN 28 839)
This International Standard specifies the mechanical properties of bolts, screws, studs and nuts - with nominal thread diameters, d, from M1,6 to M39 inclusive; - with metric ISO thread in accordance with ISO 261; - made of copper and copper alloys or aluminium and aluminium alloys. It does not ...