ISO 4757
Cross recesses for screws
English
1983
0.000
Detailed Information
This International Standard defines two types of cross recesses for screws:
– recess type H;
– recess type Z.
Included in this International Standard is a method of penetration gauging for both types.
Download File
(Log in to download spec.)
Check out other specifications
2001
English
Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method
This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws and studs; — thread rolling screws; — self-tapping screws; — self-drilling screws; — nuts; — wash […]
1970
English
Steel Conduit Thread – Thread Gauges
The "Go" thread ring gauge must be capable of being screwed by band, without the application or undue force, over the full length of the workpiece thread. The "Not go" thread ring gauge must be incapable or passing over the thread. The "Go" thread plug gauge must be capable of being scre […]
1982
English
Disc wheels for motor vehicles and trailers – Fasteners for stud centring
This standard specifies requirements for fasteners for stud-centred disc wheels on motor vehicles and trailers. Any necessary draft on the hexagon shall be within the tolerance on the width across flats.
2000
English
UNHARDENED STEEL WASHERS
1.1 This specification covers round and miscellaneous shape steel plain (flat) washers furnished in an unhardened condition. 1.2 The washers are intended for general use bolt, nut, and stud applications to provide increased bearing surface, spacing, and to prevent galling. 1.3 Unless othe […]
2008
English
SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS
This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat-treated machine screws, tapping screws, and sems (the washers of screw-washer assemblies are exc […]
2000
English
ALLOY STEEL SOCKET SET SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel socket set screws (SSS) 0.060 thru 2.000 in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlement te […]