DIN 937
Hexagon thin castle nuts (previous design)
English
1983
0.000
Detailed Information
This standard gives specifications for hexagon thin castle nuts with metric threads ranging from 6 to 52 mm nominal thread diameter, assigned to product grades A (up to and including 16 mm nominal thread diameter) and B (above 18 mm nominal thread diameter).
Download File
(Log in to download spec.)
Check out other specifications
1993
English
Slotted spring-type straight pins (ISO 8752: 1987) English version of DIN EN 28 752
This International Standard specifies the characteristics of slotted spring-type straight pins with metric dimensions and nominal diameters, d1, from 1 to 50 mm Inclusive.
1999
English
CADMIUM OR ZINC CHROMATE ORGANIC CORROSION PROTECTIVE COATINGS FOR FASTENERS
1.1 This specification covers the basic performance requirements for an electrolytic or mechanical coating of cadmium or zinc followed by a chromate and baked organic coating for ferrous and nonferrous fasteners. 1.2 There are eight grades available under this standard; four for zinc and four for...
2001
English
Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method
This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws and studs; — thread rolling screws; — self-tapping screws; — self-drilling screws; — nuts; — washers whic...
1992
English
Grooved pins with round head (ISO 8746 : 1986) English version of DIN EN 28 746
This International Standard specifies the characteristics of round head grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,4 to 20 mm inclusive. The displaced material to each side of th...
1970
English
Conical Shaft Ends – with External Thread – Dimensions
For connection with ISO Recommendation ISO/R 775-1969, see Explanations. Conical shaft ends are intended to take belt pulleys, couplings and gears. Sizes and details such as chamfer, centre bore and surface quality, which are not specified, are to be designed as appropriate.
5.01
2008
English
FINISH SPECIFICATION
The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Offi...