ISO/R 2101

ALUMINIUM AND ALUMINIUM ALLOYS – SHEAR TEST FOR RIVET WIRE AND RIVETS

English 1971

0.000

Detailed Information

This ISO Recommendation applies to the shear testing of aluminium and aluminium alloy rivet wire and rivets, having a diameter not greater than 10 mm (3/8 in).

Download File

(Log in to download spec.)

Check out other specifications

ISO

ISO 7046-1

2011

English

Countersunk flat head screws (common head style) with type H or type Z cross recess — Product grade A — Part 1: Steel screws of property class 4.8

This part of ISO 7046 specifies the characteristics of countersunk flat head screws with threads from M1,6 to M10 inclusive, of product grade A and property class 4.8, and with type H or type Z cross recess. If, in special cases, specifications other than those listed in this part of ISO 7046 ar...

ASTM

ASTM A194/A194M

2010

English

Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1⁄4 through 4 in. and metric M6 through M100 nominal. It also covers austenitic stainless steel nuts in the size range 1⁄4 in. and M6 nominal and above. These nuts are intended for hig...

MIL

MIL-DTL-13924D

1999

English

COATING, OXIDE, BLACK, FOR FERROUS METALS

This specification covers black oxide coatings applied to ferrous metals (wrought iron, carbon, low alloy, and corrosion resistant steels). Black oxide coatings, with or without a supplementary preservative treatment (see 3.11), may be used where a black surface is required. Only very limited cor...

JIS

JIS B 0271

2004

English

Three wires for screw thread measuring and four wires for screw thread measuring

This Japanese Industrial Standard specifies three wires and four wire for screw thread measuring (hereafter referred to as “wires”) which consist of a set of three and four wires respectively, intending to be used for measuring the pitch diameter of thread plug gauges defined in JIS B 0251, JIS B...

ASTM

ASTM A653/A653M

2000

English

Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process

1.1 This specification covers steel sheet, zinc-coated (galvanized) or zinc-iron alloy-coated (galvannealed) by the hot-dip process in coils and cut lengths. 1.2 The product is produced in various zinc or zinc-iron alloy-coating weights [masses] or coating designations as shown in Table 1. 1.3 Pr...

ASME

ASME B18.2.3.9M

1999

English

METRIC HEAVY HEX FLANGE SCREWS

This standard covers the complete dimensional and general data for metric series heavy hex flange screws recognized as American National Standard.