DIN 2095

Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs

English 1973
0.000
DIN
Detailed Information

This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compression springs can be made with wire up to about 17 mm diameter. In the range from 10 to 17 mm wire diameter the production method (cold or hot coiled) depends on stressing, the material and the use of spring; cf. also DIN 2089 Sheet 1 (Preliminary Standard).

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 7980
1972
German

Federringe für Zylindcrschrauhcn

Die Oberfläche der Federringe muß glatt und frei von Zunder und Grat sein. Die Federringe müssen ohne Knicke gewunden und ihre äußeren Kanten scharfkantig bis leicht gerundet sein.
DIN
DIN 562
2000
English

Square thin nuts Product grade B

This standard specifies dimensions and technical delivery conditions for sizes M1,6 to M10 square thin nuts of product grade B.
JIS
JIS B 0202
1999
English

Parallel pipe threads

This standard specifies parallel pipe threads and is applicable to the threads used mainly for mechanical connection to joint the pipes, pipe fittings, fluid machinery, etc. The parallel inter [...]
DIN
DIN 605
1981
English

Flat countersunk square neck bolts with long square

This standard specifies flat countersunk square neck bolts with long square, with metric threads M 6, M 8 and M 10, of product grade C.
DIN
DIN 268
1974
German

Tangentkeile und Tangentkeilnuten für stoßartige Wechselbeanspruchungen

Die vorliegende Norm entspricht sachlich dem ISO-Entwurf ISO/DIS 3117 -1973 Tangential keying Clavetage par clavettes tangentielles Tangentkeile und Tangentkeilnuten Dieser ISO-Entwurf enthält [...]
ANSI
ANSI B18.2.3.3M
1995
English

METRIC HEAVY HEX SCREWS

1.1 This standard covers the complete general and dimensional data for metric heavy hex screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard i [...]
DIN
DIN 101
1993
English

Rivets – Technical delivery conditions

This standard specifies technical delivery conditions, test methods and acceptance conditions for all types of standardized rivets (except for blind rivets). These specifications are generally [...]
DIN
DIN 7998
1975
English

Threads and Thread Ends for Wood Screws

Designation of a wood screw thread of nominal diameter d1 = 4 mm: Thread 4 DIN 7998
DIN
DIN 467
1986
English

Knurled nuts

The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. [...]