DIN 8221

Driving Elements – Bushes for Plain Bearings – according to DIN 502, DIN 503 and DIN 504

English 1973
0.000
DIN
Detailed Information

A long-standing desire of users to see the interchangeability of bearing bushes assured when they have to be replaced has now been fulfilled by the standardization of these bushes. The outside diameters of the bushes could not however be scheduled in agreement with DIN 1850 Part 1 (August 1970 issue), because the shaft diameters and bearing housings must be the same for bearings with and without bearing shells. The bearing bushes according to the Table are applicable to bearings according to DIN 502 to DIN 504. The dimensions correspond to those used for many years in engineering practice.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 0201
1973
English

Miniature screw threads

This Japanese Industrial Standard specifies basic profile, formulas, basic dimensions, classes, limits of sizes and tolerances for miniature screw threads of nominal diameter 0.3 to 1.4 mm used [...]
DIN EN
DIN EN 28733
1992
English

Unhardened parallel pins with internal thread (ISO 8733 : 1986) English version of DIN EN 28 733

This International Standard specifies the characteristics of unhardened parallel pins with internal thread, with metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
ASTM
ASTM F436M
1993
English

Standard Specification for Hardened Steel Washers [Metric]

1.1 This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M100. T [...]
ISO
ISO 272
1982
English

Fasteners — Hexagon products — Widths across flats

This International Standard specifies widths across flats for hexagon products, for example hexagon head bolts and screws, hexagon nuts and hexagon flanged bolts, screws and nuts, to be used in [...]
DIN
DIN 8221
1973
English

Driving Elements – Bushes for Plain Bearings – according to DIN 502, DIN 503 and DIN 504

A long-standing desire of users to see the interchangeability of bearing bushes assured when they have to be replaced has now been fulfilled by the standardization of these bushes. The outside [...]
DIN EN
DIN EN 28746
1992
English

Grooved pins with round head (ISO 8746 : 1986) English version of DIN EN 28 746

This International Standard specifies the characteristics of round head grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dime [...]
ASTM
ASTM F901
2001
English

ALUMINUM TRANSMISSION TOWER BOLTS AND NUTS

1.1 This specification covers aluminum structural bolts and nuts for use in the construction of aluminum transmission towers, substations, and similar aluminum structures. 1.2 Diameters of bolt [...]
SAE
SAE J1199
1983
English

MECHANICAL AND MATERIAL REQUIREMENTS FOR METRIC EXTERNALLY THREADED STEEL FASTENER

1.1 This standard covers the mechanical and material requirements for eight property classes of steel, externally threaded metric fasteners in sizes M1.6 through M36, inclusive, and suitable fo [...]
ASME
ASME B18.16.6
2008
English

NYLON INSERT LOCKNUTS (INCH SERIES)

This Standard covers the complete general, dimensional, mechanical, and performance data for carbon steel, inch series nylon insert locknuts of property grades NE2, NE5, and NE8 designated as A [...]