Check out other specifications
2001
English
Phosphate conversion coatings of metals – Method of specifying requirements – English version of DIN EN 12476
This European Standard specifies a method of specifying requirements for phosphate conversion coatings, intended primarily for application to ferrous metals, aluminium, zinc, cadmium and their alloys (see annex A).
2002
English
SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS
This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs. including heat treated machine screws, tapping screws, and SEMS (the washers of screw-washer assemblies are ex […]
1956
English
Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application
No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
2000
English
ALLOY STEEL SOCKET SET SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel socket set screws (SSS) 0.060 thru 2.000 in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlement te […]
1984
English
Fasteners – Technical delivery conditions – Design and dimensional accuracy
This standard supplements DIN ISO 4759 Part 1 and applies to those product standards (dimensional standards) in which DIN 267 Part 2 is referred to, e.g. with regard to the surface roughness of bolts, screws and nuts.