Check out other specifications
1987
English
Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B
This standard specifies requirements for M6 to M52 hexagon slotted nuts and castle nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regar […]
1999
English
CLEARANCE HOLES FOR BOLTS, SCREWS, AND STUDS
This standard covers the recommended clearance hole sizes for #0 through 1.5 inch fasteners in three classes of clearance using a close-, normal-, and loose-fit category.
2006
English
CARBON AND ALLOY STEEL COMPRSSIBL-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH CAP SCREWS, BOLTS, ANCHORS, AND STUDS
1.1 This specification covers the requirements for carbon and alloy steel compressible-washer-type direct tension indicators capable of indicating a specified bolt tension in cap screws, bolts, anchors, and studs. 1.2 Direct tension indicators in nominal diameter sizes 1/4 through 2-1/2 i […]
1980
English
ISO general purpose metric screw threads – Tolerances – Part 1 : Principles and basic data
This International Standard specifies a tolerance system for screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The tolerance system refers to the basic profile according to ISO 68, ISO general purpose screw threads - Basic profile.
1995
English
UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)
This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0.600 to 6.000 in., and specifies limiting dimensions and tolerances. It specifies the characteri […]