JIS B 1091

Fasteners—Acceptance inspection

English 2003
0.000
JIS
Detailed Information

This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases where no other such procedure was agreed with the supplier at
the time the fasteners were ordered. Additional requirements for acceptance may be included in a specific product standard (for example, one on prevailing torque type nuts). The same procedure is also to be applied in cases where conformance to
specification is disputed.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 908
1992
English

Hexagon socket screw plugs

This standard specifies dimensions and technical delivery conditions for screw plugs which are intended to be screwed into holes with parallel thread as specified in DIN 13 Part 5, 6 or 7, or I [...]
DIN
DIN 6902
1990
English

Plain washers for screw and washer assemblies

Washers as specified in this standard are intended for use with screw and washer assemblies as specified in DIN 6900 Parts 1 to 3.
JIS
JIS B 1045
2001
English

Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method

This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws a [...]
DIN
DIN 186
1988
English

T-head bolts with square neck

This standard specifies M 6 to M 48 T·head bolts with square neck. They are designed for use in attaching components to foundations or similar structures by means of T·slots (such as are specif [...]
JIS
JIS B 1091
2003
English

Fasteners—Acceptance inspection

This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases wh [...]
NASM
NASM 24693
1999
English

SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 100°, CROSS RECESSED, UNC-2A AND UNF-2A

MATERIAL CODE: "A" BEFORE DASH NUMBER - ANODIZED, ALUMINUM ALLOY SCREW. "B" BEFORE DASH NUMBER - UNCOATED, BRASS SCREW. "BB" BEFORE DASH NUMBER - BLACK CHEMICAL FINISH, BRASS SCREW. "C" BEFORE [...]
JIS
JIS B 1009
1991
English

Bolts, screws and studs — Nominal lengths, and thread lengths for general purpose bolts

This Japanese Industrial Standard specifies nominal lengths to be applied to external thread parts of bolts, machine screws, etc. to be used generally and thread lengths for general purpose bol [...]
IFI
IFI-301
2008
English

GAGE CALIBRATION REQUIREMENTS AND PROCEDURES FOR THREAD GAGES

All UN, UNJ, M, and MJ thread form gages shall be calibrated using the commonly accepted metrology techniques described in this standard using properly maintained standard metrology equipment. [...]
BS EN
BS EN 14399-1
2015
English

High-strength structural bolting assemblies for preloading Part 1: General requirements

This European Standard specifies the general requirements for bolt/nut/washer(s) assemblies for high-strength structural bolting, which are suitable for preloading. The intended use of bolting [...]