ASME B18.10

TRACK BOLTS AND NUTS

English 2006
0.000
ASME
Detailed Information

This Standard covers the complete general and dimensional data for inch series oval neck and elliptic neck track bolts and square nuts intended for use with these bolts, and recognized as an American National Standard.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 608
1981
English

Flat countersunk square neck bolts with short square

This standard specifies flat countersunk square neck bolt with short square, with metric threads M 10 and M 12, of product grade C.
DIN
DIN 466
1986
English

Knurled nuts with collar

The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. [...]
DIN
DIN 267-15
1983
English

Fasteners – Technical delivery conditions – Prevailing torque type nuts

The property classes, mechanical and performance properties and the methods of test listed in this standard apply to prevailing torque type nuts - with nominal thread diameters from 3 to 39 mm; [...]
JIS
JIS B 1054-1
2001
English

Mechanical properties of corrosion-resistant stainless-steel fasteners— Part 1 : Bolts, screws and studs

This part of JIS B 1054 specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic grades of corrosion-resistant stainless steels when tested ov [...]
ISO
ISO 1481
1983
English

Slotted pan head tapping screws

This International Standard specifies the characteristics of slotted pan head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
DIN
DIN 7990
1989
English

Hexagon head bolts for structural steel bolting for supply with nut

This standard specifies requirements for M12 to M30 hexagon head bolts for supply with hexagon nut, assigned to product grade C, for use in structural steel bolting. These bolts shall always be [...]
JIS
JIS B 1044
2001
English

Fasteners—Electroplated coatings

This Standard specifies dimensional requirements for electroplated fasteners of steel or copper alloy. It specifies coating thicknesses and gives recommendations for hydrogen embrittlement reli [...]
JIS
JIS B 2804
2001
English

Retaining rings

This Japanese Industrial Standard specifies retaining rings, which are generally used on a shaft or in a bore, of the following shapes: a) C-type retaining ring, of which the shape is like a le [...]
DIN
DIN 1624
1987
English

Cold reduced mild unalloyed steel strip in widths not exceeding 650mm – Technical delivery conditions

1.1 This standard applies to cold reduced flat products (strip and lengths cut from it), without coating, in widths not exceeding 650 mm and thicknesses up to 6mm, made from mild unalloyed stee [...]