DIN 267-2

Fasteners – Technical delivery conditions – Design and dimensional accuracy

English 1984

0.000

Detailed Information

This standard supplements DIN ISO 4759 Part 1 and applies to those product standards (dimensional standards) in which DIN 267 Part 2 is referred to, e.g. with regard to the surface roughness of bolts, screws and nuts.

Download File

(Log in to download spec.)

Check out other specifications

IFI

IFI-119

2008

English

STRUCTURAL FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements of inch series structural flush break pull mandrel self-plugging blind rivets suitable for use in joining the component parts of an assembly. A metric series counterpart standard is in existence under designation ...

DIN

DIN 962

1990

English

Designation system for fasteners

This standard specifies a system of designation for bolts, screws, studs and nuts (‘fasteners’, for short), and also gives supplementary order designations for special features and finishes of such fasteners (e.g type of thread, thread end, slotting of bolt head or nut, hardness). Where no specif...

DIN EN

DIN EN 28744

1992

English

Full-length taper grooved pins (ISO 8744 : 1986) English version of DIN EN 28 744

This international Standard specifies the characteristics of full-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to each sid...

ASTM

Abstract of ASTM A325M

1993

English

HIGH-STRENGTH BOLTS FOR STRUCTURAL STEEL JOINTS [METRIC]

1.1 This specification covers requirements of various types of quenched and tempered steel bolts in nominal thread diameters M16 to M36 inclusive, commonly known as "high-strength structural bolts," intended for use in structural joints that are comparable to those made under the Specifications f...

ISO

ISO 1302

2002

English

Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation

This International Standard specifies the rules for the indication of surface texture in technical product documentation (e.g. drawings, specifications, contracts, reports) by means of graphical symbols and textual indications. It is applicable to the indication of requirements for surfaces by m...

BS EN

BS EN 10025-4

2004

English

Hot rolled products of structural steels — Part 4: Technical delivery conditions for thermomechanical rolled weldable fine grain structural steels

Part 4 of this document, in addition to Part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the thermomechanical rolled condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical pr...