DIN 431
Pipe nuts with thread as in ISO 228-1
English
2000
0.000
Detailed Information
This standard specifies dimensions and technical delivery conditions for sizes G 1/8 to G 6 (hexagon and octagon) pipe nuts with thread as in ISO 228-1 and of product grades B and C.
Download File
(Log in to download spec.)
Check out other specifications
2001
English
Mechanical properties of corrosion-resistant stainless-steel fasteners — Part 2 : Nuts
This part of JIS B 1054 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic grades of corrosion- resistant stainless steels when tested over an ambient temperature range of 15 °C to 25 °C. Properties will vary at higher or lower temperatures.
2000
English
HEX COUPLING NUTS
1. All dimensions are in inches. 2. Top Surfaces of Nuts. Nuts shall be double chamfered. The diameter of chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The length of chamfer at hex corners shall be from 5 to 15 percent of the basic thread ...
1956
English
Taper Key Torque Transmission – Parallel Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
1999
English
RIVET-TUBULAR, OVAL HEAD
DOUBLE SHEAR STRENGTH CARBON STEEL RIVETS 32,000 PSI MIN. BRASS RIVETS 35,000 PSI MIN. ALUMINUM RIVETS (2117) 26,000 PSI MIN. ALUMINUM RIVETS (5056) 24,000 PSI MIN. NICKEL ALLOY (MONEL) RIVETS 49,000 PSI MIN. COPPER RIVETS 24,000 PSI MIN. CORROSION RESISTANT STEEL RIVETS 65,000 PSI MIN.
1984
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Ausführung und Maßgenauigkeit – Beispiele für Toleranzangaben
In den nachfolgenden Bildtafeln sind - nach den Produktklassen A, B und C (bisher Ausführungen m, mg und g) geordnet - die aus DIN ISO 4759 Teil 1 und den bisherigen Festlegungen in DIN 267 Teil 2, Ausgabe April 1968, entnommenen Maßtoleranzen den verschiedenen DIN-Normen über Schrauben und Mutte...