This standard specifies product grade A hexagon socket head cap screws with metric screw threads and thread diameters from 1,4 to 100 mm. If, in exceptional cases, the screws are to meet requirements other than those given in this standard, these shall be selected in accordance with the appropria...

This standard specifies requirements for screw and washer assemblies consisting of a tapping screw with f!at bearing face and a DIN 6903 captive washer

Lifting eye nuts must always be tightened so that they bear solidly on the surface they contact. Loads at right angles to the plane of the eye are prohibited. When a specific position in relation to an axis, edge or the like is specified for the lifting eye nut when screwed on, shims should be us...

This International Standard specifies the characteristics of pan head screws of product grade A, with threads from M1,6 to M10 inclusive, and with type H or type Z cross recess. If, in special cases, specifications other than those listed in this International Standard are required, they can be ...

This International Standard gives specifications for hexagon flange bolts, small series, with threads from M5 up to and including M16 and property classes 8.8 to 10.9 and A2·70.

This standard, supplementing DIN 931 Part 1, specifies requirements for M42 to M160 x 6 hexagon head bolts assigned to product grade B. If, in special cases, the bolts are to comply with specifications other than those given in this standard, e.g. regarding nominal lengths, these shall be select...