DIN 7338
Brake and clutch lining rivets
English
1993
0.000
Detailed Information
This standard specifies dimensions of, and technical delivery conditions for, steel and nonferrous metal rivets for use with brake and clutch linings as employed in automotive engineering.
Download File
(Log in to download spec.)
Check out other specifications
1990
English
Serrated lock washers with external teeth for screw and washer assemblies
Serrated lock washers as specified in this standard are intended tor use with screw and washer assemblies as specified in DIN 6900 Part 4. Serrated lock washers are mainly designed to provide electric contact between components coated with varnish, anti-corrosive agents or similar materials, by t...
1998
English
SCREW, CAP, SOCKET HEAD, FLAT COUNTERSUNK, 82°, CORROSION-RESISTING STEEL, UNC-3A
MATERIAL: STEEL CORROSION-RESISTING, IN ACCORDANCE WITH FED. STD No 66; AISI 302. 303. 304, 305. 316 OR 384 (DEVELOPED FOR COLD HEADING). MINIMUM ULTIMATE TENSILE STRENGTH SHALL BE 80.000 PSI FOR SIZES THRU 0.625 AND 70.000 PSI FOR SIZES OVER 0.625.
1999
English
COATING, OXIDE, BLACK, FOR FERROUS METALS
This specification covers black oxide coatings applied to ferrous metals (wrought iron, carbon, low alloy, and corrosion resistant steels). Black oxide coatings, with or without a supplementary preservative treatment (see 3.11), may be used where a black surface is required. Only very limited cor...
1992
English
Slotted set screws with flat point (ISO 4766 : 1983) English version of DIN EN 24 766
This International Standard specifies the characteristics of slotted set screws with flat point and thread sizes from M 1,2 to M 12 inclusive and product grade A.
1978
English
Grooved Pins, Half Length Grooved with Gorge
Grooved pins according to this Standard are positive or non-positive connecting elements. They are used for holding retaining rings, retaining washers, springs, etc., the grooved pin being seated firmly in the accommodating hole, for which tolerance zone H11 is recommended.
1997
English
Standard Specification for Carbon and Alloy Steel Nuts [Metric]
1.1 This specification covers chemical and mechanical requirements for eight property classes of hex and hex-flange carbon and alloy steel nuts for general structural and mechanical uses on bolts, studs, and other externally threaded parts. 1.2 Classes 8S3 and 10S3 nuts have atmospheric corrosion...