ISO 7416
Plain washers, chamfered, hardened and tempered for high-strength structural bolting
English
1984
0.000
Detailed Information
This International Standard specifies those hardened and tempered circular washers intended for assembIy with large series hexagon high-strength Structural bolts and nuts of diameters from M12 to M36 inclusive.
Download File
(Log in to download spec.)
Check out other specifications
1997
English
STAINLESS STEEL METRIC NUTS
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric nuts with nominal thread diameters M1.6 th rough M36, and intended for use in engineering applications requiring general corrosion resistance. 1.2 Eight groups of stainless steel alloys are covered, ...
2001
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bolts, cap ...
1983
English
Fasteners – Technical delivery conditions – Prevailing torque type nuts
The property classes, mechanical and performance properties and the methods of test listed in this standard apply to prevailing torque type nuts - with nominal thread diameters from 3 to 39 mm; - with ISO metric thread as specified In the DIN 13 standard series; - with styles as specified in the ...
2008
English
Standard Practice for Evaluating Degree of Rusting on Painted Steel Surfaces
1.1 This practice covers the evaluation of the degree of rusting on painted steel surfaces. The visual examples which depict the percentage of rusting given in the written specifications form part of the standard. In the event of a dispute, the written definition prevails. These visual examples w...
2008
English
BREAK MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of inch series break mandrel blind rivets suitable for use in joining the component parts of an assembly. A metric series counterpart standard is in existence under designation IFI-505.
1985
English
Hexagon socket thin head cap screws with pilot recess for wrench key
This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to propert...