DIN 580

Lifting Eye Bolts

English 1972
0.000
DIN
Detailed Information

The February 1956x edition of DIN 580 Part 1 specified Siemens-Martin steel St 34 or C 15 as materials for the manufacture of lifting eye bolts, at manufacturer’s choice. The present new edition of the Standard solely prescribes C 15, which is somewhat more ductile than St 34. The technical conditions of delivery have been revised accordingly. The values for the maximum permissible loadings also had to be re-evaluated in this connection.

Download File
(Log in to download spec.)

Check out other specifications

IFI
IFI-101
2007
English

TORQUE-TENSION REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS

This standard covers torque-tension requirements for two types of plating: 0.0002/0.0004 in. thickness electrodeposited cadmium plated and lubricated Grades B and C prevailing-torque type steel [...]
DIN
DIN 582
1971
English

Lifting Eye Nuts

Lifting eye nuts must always be tightened so that they bear solidly on the surface they contact. Loads at right angles to the plane of the eye are prohibited. When a specific position in relati [...]
DIN
DIN 6901
1990
English

Tapping screw and washer assemblies

This standard specifies requirements for screw and washer assemblies consisting of a tapping screw with f!at bearing face and a DIN 6903 captive washer
ISO
ISO 1478
1983
English

Tapping screws thread

This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.
DIN
DIN 7500-1
2009
English

Thread rolling screws for ISO metric thread – Part 1: Technical delivery conditions for case hardened and tempered screws

This standard specifies requirements for case hardened and tempered metric thread rolling screws with various forms of head geometry designed to produce internal threads with nominal diameters [...]
DIN
DIN 6884
1956
English

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]
DIN
DIN 436
1990
English

Square washers for use in timber constructions

This standard specifies requirements for product grade C washers. The preferred application of these washers is in bolt/nut assemblies in timber constructions.
DIN
DIN 835
1995
English

Studs with a length of engagement equal to about 2 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in aluminium alloys. As specified in DIN 267-2, the stud end thread shall be produced to t [...]
JIS
JIS B 1007
2003
English

Tapping screws thread

This Japanese Industrial Standard specifies the type and dimensions of the thread and thread ends for tapping screws with thread sizes from ST1.5 to ST9.5 inclusive.