Check out other specifications
2000
English
Blind rivets — Mechanical testing
This Standard specifies the methods of mechanical testing execute under the ambient temperature of 10 °C to 35 °C of blind rivets (hereafter referred as “rivets”) including: — shear test (see clause 3), — tensile test (see clause 3), — mandrel head retention capability test (see clause 4), — mand...
2000
English
ISO metric thread rolling screws Part 1: Types, designation and requirements
This standard specifies dimensions, the designation and requirements for design and dimensional accuracy of ISO metric thread rolling screws. For further dimensions, tolerances, materials, mechanical and performance requirements, testing and acceptance inspection of thread rolling screws, referen...
1992
English
Clevis pins without head (ISO 2340 : 1986) English version of DIN EN 22 340
This International Standard specifies the characteristics of clevis pins without head, with metric dimensions and nominal diameters, d, from 3 to 100 mm inclusive.
1988
English
Serrated lock washers
The main purpose of serrated lock washers is to permit the flow of electric current between components coated by varnish, anti-corrosive agents or similar materials, the bent ends of the washers piercing the coating when such components are joined. For such applications, the effectiveness of serr...
2008
English
NONFERROUS NUTS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this specific...
1967
English
Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application
For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the key, di...