Check out other specifications
1991
English
Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130
This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and u […]
1973
English
Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs
This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled comp […]
2009
English
Continuously hot-dip coated steel flat products – Technical delivery conditions – English version of DIN EN 10346:2009-07
This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming, of steels for construction, of steels with high proof stre […]
1984
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Ausführung und Maßgenauigkeit – Beispiele für Toleranzangaben
In den nachfolgenden Bildtafeln sind - nach den Produktklassen A, B und C (bisher Ausführungen m, mg und g) geordnet - die aus DIN ISO 4759 Teil 1 und den bisherigen Festlegungen in DIN 267 […]
1995
English
METRIC HEAVY HEX BOLTS
1.1 This standard covers the complete general and dimensional data for metric heavy hex bolts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standar […]
1983
English
Fasteners – Technical delivery conditions – Property classes for nuts (previous classes)
DIN 267 Part 4 was converted to the international property classes for nuts in 1967. The previous symbols 4D, 5D, 5S, 6G, 6S and 8G were replaced by code numbers 4, 5, 6, 8, 10, 12 and 14 w […]
1992
English
Hexagon head bolts – Product grade C (ISO 4016 :1988) English version of DIN EN 24 016
This International Standard gives specifications for hexagon head bolts with threads from M5 up to and including M64 of product grade C. If, in special cases, specifications other than tho […]