Check out other specifications
1998
English
Technical drawings—Screw threads and threaded parts—Part 3 : Simplified representation
This part of JIS B 0002 establishes rules for the simplified representation of threaded parts, with the exception of screw thread inserts, which are covered in JIS B 0002-2. This representation is applicable when it is not necessary to show the exact shape and details of the parts (see JIS B 0002...
1993
English
METRIC HEX FLANGE NUTS
1.1 This standard covers the complete general and dimensional data for metric hex flange nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all of the nut sizes in conjunction with the various options described herei...
1970
English
Tapping Screws – Application and Core Hole Diameters
Set out below are some guidelines for the application of tapping screws. The fastening methods shown are to be deemed as examples. Tapping screws of Type B with cone end (also known as seekers) are the type predominantly used. This applies particularly when several sheets have to be fastened and...
1987
English
M1,6 to M39 hexagon head bolts – Product grades A and B
This standard specifies requirements for M1,6 to M36 hexagon head bolts assigned to product grade A for thread sizes up to and including M24 and lengths smaller than 10d or 150mm, and assigned to product grade B for thread sizes above M24 or lengths exceeding 10d or 150mm. If, in special cases, ...
1992
English
Hardened parallel pins with internal thread (ISO 8735 : 1987) English version of DIN EN 28 735
This International Standard specifies the characteristics of through hardened and case hardened parallel pins with internal thread, metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
1973
English
Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs
This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compression springs can be made with wire up to about 17 mm diameter. In the range from 10 to 17 mm wire diamete...