Check out other specifications
1991
English
General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)
This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted correctly, and also to inform the user of this standard that, for all new designs, tolerances are to be speci...
1977
English
Taper Pins with Thread Ends and Constant Taper Lengths
As part of the work of Technical Committee ISO/TC 2, ISO standards for parallel pins and taper pins have been drawn up which necessitated a general revision of existing DIN standards. In that process, a new version of DIN 258 has also been prepared which differs from the issue of March 1961 in th...
1972
English
Hexagon Head Tapping Screws
Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical conditions of delivery and material according to DIN 267 Sheet 12.
1976
English
Testing of Steel and Cast Steel – Conversion Table for Vickers Hardness, Brinell Hardness, Rockwell Hardness and Tensile Strength
The conversion table In this Standard applies - to hardness values determined according to the following standards: ~DIN 50 103 Part 1 and Part 2 (Rockwell) ~DIN 50 133 Part 1 (Vickers) and ~DIN 50 351 (Brinell) - to tensile strength values determined according t.o ~DIN 50145 and - to values of H...
1994
English
Weld bolts
This Japanese Industrial Standard specifies steel weld bolts, hereafter referred to as "bolts", for general purpose. This bolt is intended to be projection-welded at its bearing surface side of head for service, but the bolt to be welded at the top surface of head for service is excluded.