DIN 653
Knurled thin thumb screws
English
1986
0.000
Detailed Information
Where knurled thumb screws of sizes not less than M 2 shall be supplied threaded up to the head, letter A as specified in DIN 962 shall be stated in the designation (see example of designation given in clause 3).
Download File
(Log in to download spec.)
Check out other specifications
1966
English
Spring Washers with Safety Ring
The surface of the spring washer and of the safety ring must be smooth and free from scale and burr. The spring washers must be coiled with constant pitch and without any kinks (with the exception of the barbing of the ends). The ends of the spring washer which bite into the parent material must...
1973
English
Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs
This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compression springs can be made with wire up to about 17 mm diameter. In the range from 10 to 17 mm wire diamete...
1994
English
Countersunk flat head screws— Part 2 : Penetration depth of cross recesses
This Standard specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).
1995
English
TORQUE-TENSION TEST REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL METRIC HEX NUTS AND HEX FLANGE NUTS
Unfortunately, the values needed to complete this standard are not yet agreed to. ISO standard 2320 provides values which make no distinction between normal and low friction and are not accepted universally in the U.S.A. Because of the apparent absence of agreement on torque-tension values, IFI d...
2005
English
Corrosion Protective Coatings Phosphate/Electro-Organic
This specification covers the basic requirements for a black corrosion protective coating which is produced by the use of the bulk electrodeposition process or, if the parts do not lend themselves to barrel processing, the parts may be racked prior to the electrodeposition process. The process in...
2007
English
STEEL SELF-PIERCING TAPPING SCREWS FOR THE APPLICATION OF GYPSUM PANEL PRODUCTS OR METAL PLASTER BASES TO WOOD STUDS OR STEEL STUDS
1.1 This specification covers steel self-piercing tapping screws for use in fastening gypsum panel products and metal plaster bases to cold-formed steel studs less than 0.033 in. (0.84 mm) in thickness and wood members and for fastening gypsum panel products to gypsum board. 1.2 This specificati...