DIN 6799
Lock washers (retaining washers) for shafts
English
1981
0.000
Detailed Information
Lockwashers within the context of this standard are retaining washers for the axial retention of components on shafts. They are inserted radially in grooves and enclose the groove base under spring tension with segments.
Download File
(Log in to download spec.)
Check out other specifications
1998
English
Copper and copper alloys – Plate, sheet, strip and circles for general purposes – English version of DIN EN 1652
This European Standard specifies the composition, property requirements and tolerances on dimensions and form for copper and copper alloy plate, sheet, strip and circles for general purposes. The sampling procedures, the methods of test fir verification of conformity to the requirements of this ...
1985
English
Square head bolts with short dog point
This standard specifies product grade A square head bolts with short dog point and M 5 to M 24 coarse thread. Where, for special purposes, the bolts are to meet requirements differing from those specified in the present standard, e.g. in respect of nominal length or property class, the specificat...
1993
English
HIGH-STRENGTH STEEL BOLTS, CLASSES 10.9 AND 10.9.3, FOR STRUCTURAL STEEL JOINTS [METRIC]
1.1 This specification covers the chemical and mechanical requirements of quenched and tempered steel bolts, in nominal thread diameters M16 to M36, inclusive. These bolts are intended for use in structural joints that are comparable to those made under the Specification for Structural Joints Usi...
1983
English
Fasteners – Technical delivery conditions – Property classes for nuts (previous classes)
DIN 267 Part 4 was converted to the international property classes for nuts in 1967. The previous symbols 4D, 5D, 5S, 6G, 6S and 8G were replaced by code numbers 4, 5, 6, 8, 10, 12 and 14 where the code number indicated 1/100 of the minimum tensile strength of the bolt with which the nut could be...
2016
English
Materials Standards for Metal Injection Molded Parts
MPIF Standard 35 is issued to provide the design and materials engineer with the information necessary for specifying powder metal (PM) materials that have been developed by the PM parts manufacturing industry. This section of Standard 35 deals with products manufactured by Metal Injection Moldin...
1999
English
METRIC HEX CAP SCREWS
1.1 This standard covers the complete general and dimensional data for metric series hex cap screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all of the sizes in conjunction with the various options described her...