DIN EN 27436
Slotted set screws with cup point (ISO 7436 : 1983) English version of DIN EN 27 436
English
1992
0.000
Detailed Information
This International Standard specifies the characteristics of slotted set screws with cup point and thread sizes from M 1,6 to M 12 inclusive and product grade A.
Download File
(Log in to download spec.)
Check out other specifications
1991
English
Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130
This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and unless otherwise agreed at the time of ordering, equal to or less than 3 mm, delivered in sheet, coil, slit c...
2000
English
QUENCHED AND TEMPERED STEEL BOLTS AND STUDS
This specification covers the chemical and mechanical requirements for two types of quenched and tempered steel bolts and studs for general applications where high strength is required.
1970
English
Round Wire Snap Rings and Snap Ring Grooves for Shafts and Bores
The standard DIN 9045 contains snap rings capable of use in like manner for external and internal retaining duty. This necessarily entails a gap between the two ends of the wire to permit installing as an internal retaining device, in other words when being fitted the snap ring must be capable of...
2002
English
Threading tools—Vocabulary Part 3 : Chaser
This part of JIS B 0176 specifies terms and definitions related to the chaser to be used mainly for metal workings in general.
1968
English
Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application
So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h1 is the maximum height of the key (less gib head) an...
1994
English
Curved spring lock washers
Spring lock washers as covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of a property class less than 8.8, as specified in DIN EN 20898-1. They are intended to counteract the effect of setting which results In bolt/nut assembli...