DIN 1624

Cold reduced mild unalloyed steel strip in widths not exceeding 650mm – Technical delivery conditions

English 1987
0.000
DIN
Detailed Information

1.1 This standard applies to cold reduced flat products (strip and lengths cut from it), without coating, in widths not
exceeding 650 mm and thicknesses up to 6mm, made from mild unalloyed steels as specified in table 1. The steels are suitable for forming and surface refinement, but not for quench hardening or for quenching and tempering. They may be case hardened, but only the steels specified in DIN 17 210 may be assumed to be suitable for this purpose, and these are not covered in the present standard.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 8195
1977
English

Design and selection of chain drives

1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and [...]
ASTM
Abstract of ASTM F812/F812M
2002
English

SURFACE DISCONTINUITIES OF NUTS

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of nuts with nominal diameters 1/4 in. [...]
DIN
DIN 7980
1972
German

Federringe für Zylindcrschrauhcn

Die Oberfläche der Federringe muß glatt und frei von Zunder und Grat sein. Die Federringe müssen ohne Knicke gewunden und ihre äußeren Kanten scharfkantig bis leicht gerundet sein.
IFI
IFI-137
2008
English

INSPECTION AND QUALITY ASSURANCE FOR GENERAL PURPOSE BLIND RIVETS

This standard outlines the inspection plan to be used when lot compliance after shipment of general purpose blind rivets is questioned by the user. The producer is responsible for supplying a p [...]
JIS
JIS B 1099
2005
English

Fasteners — General requirements for bolts, screws, studs and nuts

This Standard specifies the general requirements for standardized bolts, screws, studs and nuts. It refers to the Standards on tolerances, mechanical and performance characteristics, geometrica [...]
JIS
JIS B 1126
1995
English

Hexagon washer head tapping screws

This Standard specifies hexagon washer head tapping screws with threads from ST2.2 up to and including ST8.
DIN
DIN 1449
1970
English

Conical shaft ends with internal thread – Dimensions

This standard specifies dimensions for the conical shaft ends with internal thread which are intended to accommodate belt pulleys, couplings and gears. See DIN 1448-1 for conical shaft ends wi [...]
JIS
JIS B 0218
1980
English

Limit of sizes and tolerances for metric trapezoidal screw threads

This Japanese Industrial Standard specifies limit of sizes and tolerances for metric trapezoidal screw threads specified in JIS B 0216. The limit of sizes and tolerances due to this standard d [...]
DIN
DIN 137
1994
English

Wave spring washers

Spring lock washers as covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of a property class less than 5.8, as specified in [...]