Check out other specifications
1977
English
Taper Pins with Thread Ends and Constant Taper Lengths
As part of the work of Technical Committee ISO/TC 2, ISO standards for parallel pins and taper pins have been drawn up which necessitated a general revision of existing DIN standards. In that process, a new version of DIN 258 has also been prepared which differs from the issue of March 19 […]
2013
English
Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
This practice covers recommendations and precautions for cleaning, descaling, and passivating of new stainless steel parts, assemblies, equipment, and installed systems. These recommendations are presented as procedures for guidance when it is recognized that for a particular service it i […]
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS – INCH SERIES
This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to inch series nuts, in nominal sizes 1/4 thru 1 inch intended for application temperatures of - 40°F to 350°F. Torque values for performance level I and level ll given in […]
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NONMETALLIC RESISTANT ELEMENT PREVAILING-TORQUE SCREWS
This standard establishes a conformance test procedure for the performance of Nonmetallic Resistant Element Prevailing-Torque Screws (hereinafter called "REPT screw"), in nominal screw sizes No. 0 thru 1-1/2 in. While the requirements of this standard apply to Nonmetallic Resistant Elemen […]